s-lcd3 meter settings

[DavieH]

Hi I fitted a S-LCD3 LCD Meter along with a so6s controller when playing around with the setting I managed screw up things up does anyone know what the setting should be or is there away of doing a factory reset?
Cheers Davie

 

[robdon]

In the C SETTINGS c10 this is the factory reset
ROB

 

[DavieH]

Hi Rob every thing was working ok until I messed about with the settings now when I twist the throttle it only works for about 2 seconds then stops.
I have to release the throttle and twist it again it works on pedal assist ok.
Davie

 

[awol]

No1 rule, always write down what settings were before altering, however if you can factory reset then your lucky.

 

[DavieH]

Factory reset done everything now working ok thank you for the help.
Cheers Davie

 

[robdon]

I have a Q100 front hub motor, So6S controller, S-LCD3 meter, 36v 11ah
I set it up as best as I could reading the instruction manual, but the peddle assist cuts out every 2or3 second, if any one has a similar setup, can they post how they set P1 to P5 and C1 to C6.
I know how to do a factory re set, as I explained to DavieH, but I do not want to keep doing that, and the instructions are terrible.
perhaps PDARNETT or DavieH can help as they have this S-LCD3 meter.
thanks
ROB

 

[DavieH]

Hi Rob my bike is at my work I will check the settings tomorrow and get back to you.
Davie

 

[DavieH]

Hi Rob my settings are P1 214 - P2 1 - P3 1 - P4 0 - P5 12
C1 02 - C2 0 - C3 8 - C4 0 - C5 10 - C6 3
The only thing that does not work correct is the speedo which reads a top speed of 10 mph there is no external speed sensor fitted to it.
DavieH

 

[robdon]

OK. thank you I will try these settings.
ROB

 

[DuncanDK]

Hi guys

In the thread below I explain the use of parameter P1 on Q100/S-LCD3 display.
I expect it to be the same on q128 and other motors/LCDs

http://www.pedelecs.co.uk/forum/threads/q100-motor-–-parameter-p1-explained-–-speed-alignment.33072/

Sincerely yours

DuncanDK