Recent content by Armadillo

Are Vandorm Express 700 x 45 any good? They are quite cheap & not too heavy a tread

P2 = 1 works really well. Now LCD speed matches bike speed sensor all the time. Thanks

There are altogether 9 wires going to rear hub. 3 motor phase! & a six pin plug - red black white yellow green blue.

I have a very old spoke magnet speed sensor on the front wheel. It transmits to a small screen on the handlebars. Is there a speed sensor that will plug into my controller & register on my LCD3 ?

Voilamart 250w hub, KT 20A controller & LCD3. System works fine but I can't get my speedometer to work accurately. I already have an old speedo on the front wheel for reference. I have adjusted the P1 value to 88 which seems to coincide with the old speedo up to 18.5 mph while pedaling. If I go...

Thanks! I'll try that.

Does anyone know the gear ratio of a voilamart 250w hub, & the number of magnets?

Thanks! Is that a square wave or sine wave 9 FET controller - not sure which is best?

KT 15A controller gets quite hot - is this a problem ?

Thanks

Thanks ! Have fitted KT controller & it works very well. Only about half a turn for PAS to cut in. Also throttle does not affect the PAS I can use either or both. - There is a grey wire ( EABS ) something to do with flexible braking - what is that ?

Thankyou ! Also it takes about 6-7 revolutions for my PAS to cut in. Is this normal ?

8 wires so must be sine wave. It has quite good torque at the moment & don't really want to lose any of that so I guess I'll be looking for a 15A + controller. - Thankyou all !!!

Does anyone know if the Voilamart 250w motor controller is sine wave or square wave ? Also - How much difference would it make to have a 13A controller as opposed to 15A ( I have a 36v 15 Ah battery )

Thanks! I may have a re-think