Recent content by daniele

Following the "07 error" of my previous mail # 694 it was a burnt MOSFET in the controller. Thanks to Andrew I now received the repaired unit, installed and now everything works perfectly ;)

Hi Nealh, sorry to hear that you have now similar issue to mine :( I also wrote and called Andrew, waiting anxiously for his reply....

This is the display showing '7' on the right hand corner. It appeared just after powering up the display. I haven't done anything special to obtain it. And honestly I don't know how to reproduce it.... As Nealh said, this is supposed to indicate 'motor stalled'.

Hi Nealh, no smell at all....the display and the wattmetre look fine to me.... thanks

hi D8veh, the cable looks fine... thanks

Just tested the PAS, I noticed the following: - Turning the disk forward, the sensor outputs a pulse signal and a RED LED indicator flashes on the sensor. - Turning the disk backward, the sensor outputs a low level signal, the RED LED indicator is not lit. In both cases the wheel doesn't move...

Hi Awol, I am not using "Brake cutoff", so I don't think this is the issue.....thanks anyway! Hi D8veh, I'll run this test on PAS as soon as I can! Hopefully this will confirm (or not...) that the issue is on the throttle. Thanks!

Hi, unfortunately my motor (front wheel) from Oxydrive kit suddenly stopped to work couple of days ago. I have used the bike for months without any problem, (the kit is still under warranty) but suddenly the motor was completely silent. Needless to say, I haven't changed anything since last...

hi D8veh, thanks for your hint ! When I try to slowly turn the wheel in both direction, I can feel the engine in the reverse mode and some (very similar) resistance on the way forward. So I am pretty sure that in my case the clutch is stuck. When you say "I've fixed one of those motors before...

Hi all, I am new to this forum and I think it is really great, lot of questions from many people and everybody keen to share knowledge! First of all a big thanks to D8veh, you have given to me so many useful hints, really appreciate :) I have completed the installation of a front wheel kit from...