Recent content by Electric Bike Rider

My pas stopped working too with error 12h so I unplugged then re-plugged the pas connector but this did not work. To get it working again I had to clean all the silicone and then after that wasn't enough had to bend the pins a bit with a screwdriver before plugging back in. This has so far...

On my new BBSHD I experience the complete opposite. PAS will always take precedence and will override the throttle. So you can be on 3/4 throttle and start pedaling on PAS 1 or 0 then the power will cut to the level that PAS would give. Unless you push the throttle all the way whilst pedaling...

Newer versions of the BBSHD and possibly also the BBS02 may disable the throttle when you turn the pedals and PAS kicks in, even when in PAS mode zero. I have a BBSHD like this and it is bit of a pain but not so bad when used to it. Or you can disable pas and have throttle only via reprogramming...

Maybe be a very big new battery included, hence the difficulty in mounting. Maybe the base bike is worth allot, the seat looks nice although the pedals and cranks look a bit budget. Looks like it has branded tyres.

Could be a bad cell (or paralleled group, unsure of your config). I run 16s 1p and if one cell was bad or out of balance and undercharged then it would hit the cell LVC first and the BMS would switch off the whole pack to protect it. Or could be a bad connection where heat expands things and...

This is probably a good idea if you don't like the idea of drilling into the frame. Also, there might be a way of getting some straps around the downtube. I don't reckon those bottle cage mounts are that strong anyway when holding a big battery. I have a bike where they have worked themselves...

I'm still looking for a way to disable PAS override on my new version BBSHD. I don't think that this box would help here.