Recent content by Jammyb

yep that was me :rolleyes:. So keen to test ride new setup whilst changing components i forgot to torque the axle nuts adequately! Won't be making that mistake again. Back up and running with another motor thanks to the help of PC2017 though :)

sounds good mate, great once you have a smooth working setup ;) . Black controller looks nice to, wouldn't look out of place mounted direct to the frame somewhere or do you have a controller box/bag

This self amalgamating table is great for that purpose, its nice and rubbery and the splines in the PAS seem to grip it better than the normal black elec tape. ( actually my fav type of tape for many diy things as its not sticky but sticks to itself when stretched. - perfect for wrapping round...

Or you can go at it a bit heath robinson, with a hacksaw and file cut off a bit of the inside edge of the pedal. mines been like this for over a year now and did the job:

I'm super lucky and hugely grateful if it is! Stupid error by me, had the bike upside down whilst testing and think i forgot to go back and torque one of the axle nuts down before going for a test run. Luckily I felt something odd when pulling off from a standstill rather than it happening at...

this is the state of my previous one:

Ow that would be fantastic! ... i think - being a bit dumb here but which part is the rotor, is that the middle bit that the axel is pressed though? If that means I could get my old wheel with the snapped axle up and running again that would be amazing :)

Thanks for that sounds pretty good! yes guess you going to have to keep a close eye on the heat once our sun ever comes back! Just a thought - could you unscrew the faceplate of the 350w motor pull it out and slot it in the other 250w wheel that's not cracked ? or are they actually different...

Ah, well this is what I thought originally but both versions of the 9mosfet KT36/48SVPRM and KT36/48ZWSRM controllers seem to have the hall control wires as well as phase so there must be more to it than that ?

Cheers CP2017, I wondered in future if the 250w winding motor run at 48v would be a better experience, with a bit stronger pull at lower speed and if it would still allow good assist between 20-23mph. Be interesting to know how you get on with your new controller and when you switch over to the...

I'm pretty sure there not crossed, wouldn't that make it just run terribly. I mean its does work perfectly ...just not quiet as smooth and quiet as the external square wave controller. Thanks Nealh - The videos are just using throttle but the PAS seems to also work fine. Do you think from the...

I think this would be the one to go for for the best external with waterproof connections: https://www.aliexpress.com/item/33004887423.html?spm=2114.12010612.8148356.13.3fce107fIZTt8X Did you get the 48v version of the integrated controller ? I've since been informed by topbikekit guys that...

Tried setting P1 to 176 yesterday but unfortunately didn't seem to make any difference. Not 100% sure if motor has 16 or 20 magnets so also tried 4.4x16 and multiples there of (P1 = 70, 140, 210) Strange though I can't detect any change in all these settings, only as previously found P1 = 60 or...

Hi PC2017 That does sound very similar to how my kit startng acting up. Seemed to start just doing random things like that brake cut out not showing whilst active and speedo not always registering. Eventually I don't think any setting changes on the lcd settings made any difference to the...

Thanks, I haven’t tried P1 that high, I have tried from about 50-115 but I couldn’t tell any difference only that it would not spin at full speed below 50-60 I also still have the 6 mosfit 36v hailong controller and battery from my original yose power kit. That combo does seem to run the motor...