Nealh's latest activity
-
Nealh replied to the thread Switching from swytch.It will all depend on the sensor type used , if switch change the sensor type then may be not. -
Nealh replied to the thread Battery dies quickly, next stop scrappy ?.I think a lot people take up beekeeping for the wrong reasons, alot being about ecology and saving the bee nonsense common and typical...
-
Nealh replied to the thread Yose 250w. rear hub motor with Lishui 350w. controller?.I think tbh Tony you are bias, we know you are a Lishui fan. Tbh there is only one setting with a KT that can really do any damage and...
-
Nealh replied to the thread Smoked controller - repairable?.Best optimised controller I have used is a KT.
-
Nealh replied to the thread My new favourite battery.Yes , as in the EAPC application . The directive is an EU one, but the UK makes it's own rules/laws up but thus far DVLA follow the EU...
-
Nealh replied to the thread My new favourite battery.EU low voltage is indeed 75v for household battery products , however EAPC's aren't included in that 75v rating and have a max rating of...
-
Nealh replied to the thread Any ideas? Thanks in advance.A mosfet test will pin point if mosfets are the cause /issue as they tend to be the most common point of failure. Testing helps to...
-
Mosfets have two modes of failure, they can go either open circuit or short circuit. A typical failure in a motor controller is a...
-
Nealh replied to the thread Wisper Never used wisper. For sale.A fair price is what some one will wish to pay, ut if using Flecc's used price guidlines it will be 40% less then the price paid and...
-
Nealh replied to the thread Wisper Centre Stand Advice Please!.Does your 705se not have the side stand fitted in front of the back wheel as some version do have it there ? Best show a pic of the...
-
Nealh replied to the thread Any ideas? Thanks in advance.After all these posts we still don't know the bike he has.
-
Nealh replied to the thread Any ideas? Thanks in advance.A controller mosfet test is carried out via the Phase wire bullet connections in your pic and doesn't need battery, It takes approx . 5...
-
Nealh replied to the thread Wisper Tailwind rear hub bearings.With both my Bafang BPM and CST , the bearings needed changing due to roughness in rotation. BPM less then 2k miles and CST a bit after...
-
Nealh replied to the thread Any ideas? Thanks in advance.Yes do check the Hall sensor block if it is the white 6 wire DJ7061, pins do a have a habit sometimes of backing out sometimes .
-
Nealh replied to the thread Switching from swytch.Typically the setting aren't all that hard to get right . P settings the main one's are P1 - P4 and like wise C1 & C4are critical...
