Recent content by VisionOn

Thank you evryone. I'll get a torx tomorrow or I might have one.

I dont think tis has been asked before appologies if it has (just point me at it). Is there a special tool needed to remove Tektro disks (because my 4 mm allen key wont fit). If so whats it called. Please see atachd photo.

What motor has the same attachments to the frame as a Bafang MM G33 or are they all the same? The newer & lighter the better.

Is m 400 the same as - mm g33.350 36v 350w 16A. Would the controller work?

Man this is far more complicated than I thought, perhaps I should use leg power for now (while there's still life left in em) I just wanted to go further is all.

Thanks could have been a costly mistake I made there I'm open to suggestions though I like the idea of a 1000W motor with a code or switch to 250W as I said I'm mainly off road, geared motor Ok now that's something else to throw into the mix. I was also looking at the offering from 8fun a crank...

Hey hello everyone, Iv'e been thinking of electrifying my bike for a year or so now She's old like me but good unlike me, a Marin Mount Vision circa 2000, I hadn't realized there were so many people out there that were kinda the same. What I would like is some advice on which way to go I think...