Search results

Shall do at some point sooner rather than later. Thanks. Also Benjahmin, new magnetic disc is fitted and working

Will bear the 3 phase connectors in mind for any future problems. The feed cable to motor has a 3 pin Julet connector with skinny little pins.

Last night I removed the controller with the mass of wiring and found no loose connections, wiggled and pushed together all connectors a bit and then resisted them. To my disappointment, power was still inactive despite several attempts . . . Tried again early this morning and unbelievably it...

As I indicated earlier, have just changed the magnetic ring (pas?) and it fired up ok on both pedal power and throttle. However tried again later and .. . No power. The motor power cable connector I had pushed hard together so as it previously worked, should rule that out. Break cut-outs...

Neal and Benjahmin, thanks for the advice. Am just about to follow your suggestions. Neal, (Neahl?) I also have a new 5 magnet crank ring and will replace the original that had broken a year or more ago and recobbled together. Benjahmin, meter appears to be functioning well with no error...

I have a 6 year old Volt Pulse ebike. It has a bafang rear hub fun 8 motor. The lcd meter is 5 wired and the controller is unlabeled and so not identified. I have been experiencing intermitent power supply to the extent that the bike is unusable due to unreliability. It seems from pedelecs'...