Torque arm fitting over hub connection

[Sutty86]

Right is there any way I can fit a torque arm over my big fat connection plug,
I'm really crap at soldering I found out that when making the battery (but it works fine) any torque arms which fit over it , I'm scared if I try disconnect the wires from the plug I'll mess it a up and break stuff.

Bike has torque arm fitted on disc side and works well, just concerned has the bike hits speeds of 35mph (GPS and I'm 16 1/2 stone lump) obviously off road...

Any suggestions

 

[Deleted member 4366]

You don't need to do any soldering. the wire comes out of the motor and goes forwards inside and around the drop-out. The torque arm goes on the outside of the drop-out.

 

[Sutty86]

I'm so sorry dv8eh I don't have a clue what your talking about I know your right (your always right)
Any simple pics hahahah

 

[Deleted member 4366]

 

[Sutty86]

Thanks dv8eh I knew I could count on you.
Invaluable to this forum