Recent content by 1Dude

its definitely 36v as it shows 42v fully charged

I dont know the ah of my existing battery as it does not have anything written on it, i know its 36v i have had a look inside and i can count over 40 cells i think 42 so i cant work it out

So after a week or so the bike has been fine really impressed with it i would like to get another battery so thinking of getting one of these ' or am I wasting my time ' you cant buy the cells for this price ...

I will set the controller to go to assist 0 when first switched on Has anyone tried these batteries ...

Well that was strange, i pushed the bike backwards out of the garage and it came back on and has remained on since ! I have noticed if you pedal backwards the motor kicks in every now and then ! is this a faulty PAS ? it seems to be one rotation could it be a magnet the wrong way around in the...

Ok i have spent all afternoon cleaning up the wiring and the bag from Aldi was made for the controller it looks good, I have one problem that i have just noticed the power bar meter on the display is not showing how full the battery is! do you have any idea ? it was working half an hour earlier...

I have been around the block now and all seems fine Thank you Nealh for your help I also got a a bag from Aldi, a little modification to it and the controller fits perfectly inside 'see pic' jut need to put a hole in the bottom of it to allow for the wires 'i will have some more soldering and...

I have been out and changed the wires on the pas and I also had to change C1 to 5 reverse signal 12 (12 magnets) as the sensor is on the right side next to the crank drive cog, not sure what it means by 07 standard 06 higher and 05 highest ? it seems to be working but cant go fare as it is...

Thanks for the reply i will give the PAS as try I have definitely got the wires wrong on the pas I had red to brown yellow to yellow black to blue so hopefully no damage done. Ref the P and C Settings i have read on here someone else has the same motor and they say its 6 magnets but when I set...

ok all the parts arrived today, so i have connected it all up allot of soldering it seems to be working off the throttle but not he pas i may have the wires on the pas the wrong way around as the colours did not match the wires on the controller are yellow black brown and the wires from the pas...

I have to say I ordered my parts from Modds E Bikes, I gave them a call first and they are very helpful. is there any standard colour coded for the Julet connectors , or do i have to use my meter to identify the brake wires etc ?

Hello Thank you for the reply I have now ordered the controller and display the hub is a 9 pin / wire see pics, the rest of the connections on the bike are Julet. When i removed the old controller i cut the wires off at the pcb, as you can see in the pics so I can either solder or fit new...

Question 1: if i purchased the T36/48ZWSRM-NBP03 500W 11 amp 22 amp max with the KT-LCD8H display Can i turn the power down using the display ? Question 2 is the display KT-LCD8H waterproof ?

Thanks for the reply I know from reading that the motor Bafang BFSWX02 36v 250W (13) (9wires) is capable of more power so do i go for the 250W controller or a 500w turning the power down in the settings a little ? i am also going for KT-LCD8H Display on whatever controller i go for due to...

Thank you for your reply, its defiantly the controller that has gone its burnt out, I have taken the cover off and its black, a couple of resister blown, i would imagine that on of the 6 fets have shorted, i would have tried a repair but the board is set in a resin. The battery is virtually...