Recent content by allanx38

Hi, after using my TSDZ2 kit for a couple of hundred kilometres, all going great, the throttle has suddenly gone nuts - it is engaged all the time, bit of a surprise first time it happened ... I bought a new throttle (wire looked a little loose on the original) but it is just the same. Has...

thanks for the replies. I have the spacing correct now, speedo increases with speed and decreases as well. One thing I didn't notice before, when I pull the brake levers (ones supplied with kit to cut the motor) the speedo freezes at the speed you are going when you pull the brakes, after...

Hi - can I just ask when using without the speed senor you simply disconnect the cable from the motor connecting to the sensor usually cable tied to the frame with the magnet opposite it? I tried this and the motor sort of comes and goes. The throttle failed recently, it was engaged all the...

Hi My TDSZ2 speed controller has gone a bit wonky. I have been fiddling around with the magnet distance from the sensor, one spoke seems too far away and no speed is recorded, the closer spoke passes very close to the sensor, almost touching it. I originally had it aligned with the round part...

Hi All, great thread this thanks. I installed a TSDZ2 and it seems pretty good. I have just installed the OSF (following the post from Swizz, cheers). Just a note v20.1C has been suspended so I used v20.1B. I have only had a short ride with the OSF (it was raining ...) so its hard to tell what...