Recent content by AlPedal

what grease is recommended for planetary gears ??

At last got to it again, Halls were glued in, damaged 2 getting them out. I've cleaned glue and damaged bits from slots. They are SS41s so have ordered 10. Is there a need for the glue ?? They will be pretty tight and keeping legs to PCB the right length I think they'll be stable. If I need...

metering between -ve and hall signal pin, green nothing, blue and yellow both switching. green continuity to controller OK. Motor shows no signs of water ingress. are Halls glued in ? I can release its PCB but halls seem tight.

just had an hour on motor. All 3 halls appear to meter the same, i.e. signal to ground on all 3 is same, signal to +ve on all 3 is same etc etc but the measurements are different. I think the hall appears good. signal pin to plug continuity is good. tomorrow need to check green continuity all...

OK, Thanks again for all the help I wont get to motor till tomorrow I'll let you know what I find

Yes have double checked motor connector is fully inserted up to line

Where motor cable enters hub there is damage to outer sheath, but not to interwoven screen, could green wire be damaged here ? is this diy fixable by stripping motor ??

When I power up display after about 10 secs it powers down. is this battery save feature ?? or a fault of some kind ??

OK, would appear to be green Hall sensor not responding as per the other 2 Where do I go from here ? Is the motor a diy strip down job ?? other option was hall less controller .... what do I lose ?

5pin is Red/Blue/Black/Green/Yellow. 6pin is Red/Blue/Green/Yellow/Black/White I was assuming 5pin to be hall as its 5 pin in the testing link you sent

I also have two 2pin with black/white cables, one 3pin Red/black/blue cables What are these ? 2x brakes and one crank sensor ??? I guess

Thanks for all the help Mosfets seem good, I'll get to hall sensor testing tomorrow I have one 5pin and one 6pin connector, how can I be sure 5pin is hall ? do I have to follow wire ? I assume the other one is the display

Any one recommend a cheapish replacement ?? Dont want to spend much when argos full bike replacement is less than £300 (but will this be any better ?)

just found controller, Model b-wzkd3613ka-jm102-f4 made by tianjin santroll. Its full of 'hot glue', as per piccy, so no chance of getting to pcb for test/repair. are these good ?? reliable ?? how can I test it ?

No drive when i enable walk mode either