Recent content by Aussie

Hello Rikard ! Thanks for your comprehension ... About your question, yes ... my motor hub is equipped with hallsensors. The harness is made up of: - a "big" white male connector with 5 wires : black (gnd), red (+5V), blue (sensor 1), green (sensor 2) and yellow (sensor 3); - three single wires...

Hi RikardiLandi ! Sorry for the delay in answer ... My 1st e-bike is ready to road check ... the parameters are tested only with the rear wheel "free" (raised a few centimetres from the floor) ... When I will make the test on the road, I will get the correct data, but I need time ... Just to...

Hi Spinnzanz ! Thanks for your reply . Yes, of course, in my LCD PAS and THL are presents, but I have some news for all us, owners of this kind of LCD/controller. Yesterday, I have make some test changing only a parameter at a time . The P05 parameter is settintg to "2", thats means 9 level of...

Hi everybody! I have read more times all the 16 pages of threads and I have found a lot of interesting informations. In any case, I have some questions, that I need to find an answer to know the controller more. Here attached you will find a picture of my controller (model 866C-6) with the...

Hi to everybody and thanks to the welcome ! Before open a new thread, I will check if are present solutions for my issue. If not, I will need your help. Have a nice day !

Goodmorning everybody ! My name is Davide from Italy. I'm building my first e-bike ... with many and many troubles ! Thanks, in advance, to everyone who will help me !