Recent content by averhamdave

No but the rear wheel motor was replaced by an Ebici dealer in Spain a couple of years ago. I bought the bike very cheaply and with the new motor it has been excellent - HOWEVER durong my ownership this fault has always been there. I guess I'm answering my own question!

Thanks, my separate investigations are leading me to that conclusion yes. I'm away in Spain at the moment and will take it down when I get home.

I can sort a picture out but can you help by telling me specifically what you're looking to se? Thanks.

Thanks that sounds feasible. I don't recall seeing a set up screen for that so I need to be doing a bit more research thanks.

Speed - the bike is found maybe 12mph and the indicated speed may be 1.8mph. It varies by an onconsistent factor. Never shows more that 2.7mph.

I have a EBici bike here with faults. I have been through the set up procedure a few times but to no avail. The faults - power assist comes in and out randomly and the amount varies regardless of the level (1 to 6) selected. The display shows inaccurate information regarding speed etc. Is...

That's the case with some but many don't need pedal movement. I put a throttle on someone's otherwise "pedelec only" Falcon Ebike some time ago (the plug was sat there ready for it in the controller box) and that powers off from standstill. Most of the Chinese ebike kits are the same. This bike...

I'm dealing with a simple controller here. I dont see the throttle itself having much effect. I'm pretty sure there'll be a mod that can be made to the board to achieve what I'm trying to do.

I have a Chinese generic 36v rear hub drive, silver fish battery powered bike come into my possession. It had no battery so I've fitted a spare 48v battery that I had. All runs well, surprisingly good bike. There's a 2 position selector switch on the left side. "Start off" or "Pedal" There's a...

Yep that's the one Paul thanks and well spotted! Are my pics clear enough for you to see the board d8veh?

If still not sharp enough I'll dig my digital camera out and have another go as the phone camera obviously has its limitations. Thanks

Ill be back soon with more pics thanks

Hope that's come through ok. The controller housing states 48v. There are no jumpers to change the LV cut off

Hi, can anyone help? I have been running a 500w MXUS kit on a bike for nearly 2 years and with a couple of thousand miles on it can say its fine. Its been running 14S Lipos and a shunt soldered to give 30a peak draw. Whilst it has been fine I have tired of messing with lipos and have fitted a...