Recent content by blu joe

Ok thanks for the advice, i will get some thicker wire, what size do you recomend?

How many amps could i run this DD Hub motor at? Currently usimg 500w square wave controller. Does this motor seem big enough for 1000w?

Could have the cruise controll wires still connected so the motor keeps going on cruise, the cruise wires are usually black and blue and the wires are likely bridged with a connectot, remove it

Dude that is clearly a direct drive hub motor not geated

This is this the other side, the 5 wires go into the axel, then where?

How can i translate these 5 hall wires into standard colouring? Red, brown,orange,yellow and green?

It is particularly the throttle sensor wire coming out of the controller that i am unsure of

Accidentally cut the display, throttle, abd pas wires, please help me id the correct wires to add new SM plugs, see pics of controller and plugs to add:

Hall wires: So from other information i have figured out the phase and hall sensors colours match (brown,white,grey) , the thick sleaved black wire is ground, the orange wire is +5v, and the green wire is unused, or a thermal sensor, or speed sensor, hoping its a speed sensor as my kt...

Li

I also have another hub motor i do not know the hall wire sequence, here in this pic

My controller is sensored, i need to know the colours on which is the power wires so not to blow the hall sensors

I have a sparta ion 40nm rear hub motor, i need to add the hall wires to the controller, i remove the inbuilt controller from the hub and added the 3 phase wires, but i am unsure of the wiring sequence for the 5 hall wires There are 5 small wires coming from the central axel in the hub, they...

Is it possible to connect some sort of brake sensor from my hudraulic brakes to my KT controller?

Octalink cranks are wider than the standard square taper, i believe.