Recent content by Chris Jones

Hi, I tried before flipping and it worked the right way round, so all good. Now with a controller and motor running I have given the battery a good test. It does struggle going up inclines drops down to red and recovers when levels out to half, unsure of range yet though. Any suggestions for...

Thank you all that have contributed to this post. All up and running, you have made a real difference, thank you. I have learnt a lot and want to upgrade even further now!

Thank you d8veh How do you test the PAS? Do you use the throttle at all? Can you test when bike on a bike maintenance stand? Sorry so many questions, but never ridden this bike as got faulty.

Thank you d8veh Here they are. File3.jpg from the bike.Left to right. PAS cable, Throttle, 2xBrakes. Motor and Power connect fine.

Hi, update. Found a controller with wires that are so close to the original. And all seems to work, I.e turn throttle and motor spins. So motor works yey! But PAS not connected yet. So from the controller I have three cables that I need help with. Two are both three pin connectors...

I measured the current with 2 12v lamps in series. 1.8amps was measured with a multimeter. I stopped the test after 3h45 as that was the calculated runtime. I believe the combines wattage of the lamps was about 45 Watts. Do you think something is wrong?

Thank you d8veh. I have done a load test on the battery using 2 car lamps. Total load approx 1.8 amps. Lasted over 3hr 45 which I calculated as expected run time. Awaiting cost from SportsHQ via email / options they have, if not I will go to Aliexpress and wait. Thank you. Will update post...

Thank you d8veh. I have tested the hub motor again in the reverse direction this time and with me spinning as fast as I can with one hand (other one holding the meter!) I got 5Vac from all three phases. This is a good sign right? How can I test the battery easily? Tried Amazon for the PSWpower...

Thank you Benjahmin. The battery seems good. Good point about the geard hub, however resistance was different on all three Phases of. The controller when opened up smells of burnt pcb. Charred components and tracks. I have attached some pictures that will hopefully help you good folks.

Hi Folks Purchased one of these with expectation that I would need to replace controller and hub motor. The bike is solid, gears and brakes good. The controller is Burnt out so need one of these. Motor leads Green,Blue,Yellow have all different resistances and no AC when you spin up manually...