Recent content by dazzer10

noticed my rear wheel was not spinning freely when i tight up the bolts on the wheel , The problem is i need a washer big enough to fit over the axle but small enough so it fits in to the freehub, I have some washers that will fit on the axle but they are to wide and when i tight up the wheel...

i picked up a new front derailleur and i can use all three cogs but the problem i am having is, from the largest cog it will go to back to the middle but it wont go back to the small cog , i can hear it trying to but wont move i am not sure if its the settings or not ..

i am new to the ebike batteries but i think most of the batteries on ebay come from china , The one thing i do is never store them in my house, i sent the link they have an option if 30 a bms and 40 . XGO 52V 17.5Ah Battery 1000W 1500W Samsung Li-ion Lithium Electric Bike Downtube | eBay

I was looking for a second battery for my bike on ebay , Its probably not the best time to buy one but i was looking for a 52V 17.5Ah Battery 1000W 1500W 40a bsm , What prices would these go for in the UK? I don't know if things have gone up in price because of lock down so i might wait but...

does it matter what speed front derailleur i get, the cassette is 7 speed , gear shifters 7 speed , I am thinking of changing the chain from 9 to 8 speed ,

Well it never worked that great before the conversion but the front is Shimano Acera Low Clamp, 34.9mm, Bottom Pull, 3x9-Speed, maybe its just old and worn , It could be because i changed the gear shifter from 9 speed to 7 speed ? or my front crank is 9 speed and the cassette is 7 speed...

I have an mtb that had a conversion kit installed it has 7 speed cassette and a triple front , the bike originally had a triple cog in the front but since it had the conversion it could only use two cogs in the front, so i was thinking would it be better to use the two bigger front cogs ?

think i took about 1mm off the D/O got them both level on both sides which was mostly my goal to do because i was a bit worried about not getting them both at the right level , so i am going to test the brakes to see if there good when i finished the build .

How deep ?

Just want to make sure if this is ok and it is all safe , I have torque arms for both sides, the 3rd picture shows i can screw this to the frame i would need to drill a hole in the arm and bolt and screw, the last shows i could use both the screw and the metal tie , just wondering what...

I don't know much about theses type of batteries but i noticed its gone from 50v to 51.99v i have got it left on charge to see, there are know lights coming on from the battery and i am sure they are green and red light to show the charging state so maybe if i leave it on charge it will...

Yes i did this in the tests . https%3A//i.imgur.com/rGuiGby.jpg[/img]']

sorry your right when i said motor wires i mean the wires that power the motor are 2.928v on and 50.06 v off , and the 3 pin power is 50.06v

the batter motor wire read then on 2.928v

ready 50.06v on or off