Recent content by DJG

Thanks for the information, all I need to do now is find a battery pack that I can fit into the case, the battery is still working but goes flat quite quickly.

Its 42 volts

This is the pack inside and has 5 wires, all the packs I have seen have 4 wires and are bigger and would not fit in the case.

I am looking for a MiRider /onebot replacement battery, the battery has 5 terminals but all the battery packs to fit inside the case have 4 why is this and where can I find the right battery for the bike?

I have two MiRider one bikes, one has a 3 power controller and the other a 5 power controller. I can get to the options menus of both bikes but not sure what all the settings are and want to check that the bikes are set correctly. Also one on the bikes has a low range and I think the battery may...

Ok thanks, if it doesn’t work will just use leg power and the throttle, it’s so much better than nothing working which is where I started from.

Yes disconnected learn wire and tried pedalling backwards but still no working

I have the motor going the right way and the throttle works but I cannot get the pas to work even though I get a pulse when the magnet passes the sensor

It has the wires which I connected together, the motor ran in reverse so I disconnected the wires and then reconnected and it ran the right way, is there more to the self learning process?

Pulses are more defined with 6 magnets but only started the motor once and the would not do it again. Should the motor start when it pulses 5v or 0v?

How many pole is the best, and do I leave the magnet setting on 12 when using six magnets?

Hi there, I got a pedal assist disc and sensor and have tried it before making any brackets to fit it and have connected it as per photos, I have a 5v feed to the red and take a neutral from the black and when moving the disc across the sensor get a pulse of 5v on the blue but the motor doesn't...

Connected the white of controller to black of speed sensor and an earth to red of speed sensor and I get a reading on the display, going to road test and check speed against a gps and adjust P18 to suit. Have ordered pedal assist sensor and magnet disc and will fabricate it to fit and hopefully...

The white wire is showing 5v I thought it was pulsing when checked before

I have tried the different combinations that you suggested and changed PO7 to 1 but still no display of speed.