Garry Hallam's latest activity
-
GGarry Hallam replied to the thread LcD Display.Oh great lets hope I have saved the settings correctly. It dries up later so maybe get the chance to test it again.
-
GGarry Hallam replied to the thread LcD Display.Oh Heck! The police are checking Ebikes around here at the moment. I guess the only way round it is to repurpose the motor to another...
-
GGarry Hallam replied to the thread LcD Display.I think I may have saved the settings. Unable to road test at the moment but spinning the crank indoors gets up to 26mph. I guess...
-
GGarry Hallam replied to the thread LcD Display.I have had the bike running but cannot get it to save the maximum speed setting. The procedure I followed was: 1 Power on 2 hold...
-
GGarry Hallam replied to the thread Motor Id.I know what you are saying. I should have been clearer that it is temporary. It screamed the same to me. That battery belongs to my...
-
GGarry Hallam replied to the thread Motor Id.Just done a 20 mile trip and performed very well. Here she is on Marple Aquaduct
-
-
GGarry Hallam replied to the thread Motor Id.The only other thing concerning me is where the motor cable exits the Axle slot. There is a spring which is supposed to protect the...
-
GGarry Hallam replied to the thread Motor Id.The only place to fit my battery on this frame is on the top tube which is only 32mm diameter. It was somewhat wobbly with standard...
-
GGarry Hallam replied to the thread Motor Id.
-
-
GYou need to make a special cable shown on the last page of the manual, and it depends which connectors you have on your devices. All it...
-
GGarry Hallam replied to the thread LcD Display.What Cable do I need to transfer settings from lcd4 to 880 controller?
-
GGarry Hallam replied to the thread Motor Id.I made the spacer for behind the disc adaptor. Basically, I bored another adaptor out and skimmed to the width needed. There is a...
-
GGarry Hallam replied to the thread Motor Id.Cheers I will try it
-
GIf it's not inline, put a 6mm washer (or 2) between the caliper adapter and frame at the back fixing.
-
GGarry Hallam replied to the thread Motor Id.I had not considered that. I will have to check it
