Recent content by Indigodee

Here are some photos of the hub with the planetary gear removed. As you can see the drum is too big to go past that ring gear!, help! Dee

I will takes photos when I go to my garage. As I said, the planetary ring gear goes around the hub, and the motor is too big to go past this! That's why it's got me stumped! The only other thing I can think is that perhaps the ring is threaded, and maybe comes out on the same thread as the hub...

does anyone know how to get the motor out of the hub on the 906 alpino? So far I've managed to unscrew the side plate on the right, which gives access to the plane try gears. But as for the other side, I've had no luck! I can't seem to see anywhere it might open, usually when the plate is...

i am looking for a couple of suitable Hall effect trannys! To race in my direct drive wheel. The numbers on the ones I dug out were unreadable so don't know which to get. I do know they need to be the type with the feathered edges, in order to fit in the slots. Any help greatly appreciated...

They are front wheels, I've tried connecting it up to a standard hall sense controller and left white open, but nothing, I wasn't sure if it needed a specific controller with the extra connection, or if it went to a speed sensor attached to the fork/spokes. They don't seem to have been around...

Thanks d8veh, I'm not sure about canbus either. So I'll just get a bms and replace it , should fit in the case ok, the only issue I can see is the cells are connected to the bms via a ribbon cable, so I'm not sure if I'd be able to re-use it, in which case I'll just have to rewire it. Still...

Further to recent post, I forgot to mention, that no voltage is present on pins 2 and 4 unless the charge indicator button is pushed! So I think the 5v to centre pin is needed to tell bms of charger presence.

Thanks for all replies, I may as d8veh reckons change the bms, there are a few on eBay that look like they'll do the job, 40 cell 10s4p but they come from china! So not sure whether I will be hit with duty at the border! From what I can gather so far, the charger supplies 5v to the centre pin...

Hi, do you still have this charger? Thanks. Dee

I just managed to pick up a new in the box Powerpack 300 battery, and I want to use it with my x-byke, I was hoping that maybe somebody here, flecc maybe, might be able to help with the pinout of this battery! I will be looking to buy a 36 v lithium charger, and will hopefully be convertinting...

Hi all, newbie here, and not meaning to hijack the thread, but I have just been given a Giant LaFree Lite, but it doesn't have a charger! My question is does anyone know of a suitable charger to be found in the uk? Also what is the pinout of the giant charger plug/battery? I have managed to...