JohnD135's latest activity
-
JJohnD135 replied to the thread Modifying to Torque Sensing.Thanks All, the bike is now functioning properly and i have had a four hour run today with no issues. The drive is a little quieter...
-
JJohnD135 replied to the thread Modifying to Torque Sensing.Thanks saneagle. Throttle now functions as expected and I get rotation of the rear wheel. Now looking at the feed to the PAS. I...
-
JJohnD135 replied to the thread Modifying to Torque Sensing.Will I break it if I get the wires round the wrong way?
-
JJohnD135 replied to the thread Modifying to Torque Sensing.Having got busy with the multimeter, am I correct that I am looking at a Hall Effect sensor?
-
JJohnD135 replied to the thread Modifying to Torque Sensing.Yes it is much appreciated saneagle. I have received a new controller to replace the one that is failing and as you warned me, the wire...
-
JJohnD135 replied to the thread Modifying to Torque Sensing.I shall keep my fingers crossed that I don't have to do it.
-
JJohnD135 replied to the thread Modifying to Torque Sensing.Thanks again. If I need a speed sensor, would this be a reed relay and magnet on the wheel, or does it need to be synchronized? As to...
-
JJohnD135 replied to the thread Modifying to Torque Sensing.I checked carefully and you are correct! I was using my somewhat unreliable memory. From the motor connector I have three thicker...
-
JJohnD135 replied to the thread Modifying to Torque Sensing.Hi All. The controller (KT) has arrived and I have started fitting. The plug to the motor was too stiff to fit onto the old motor plug...
-
JJohnD135 replied to the thread Modifying to Torque Sensing.Thanks saneagle. Can you recommend? The bike is 2002 so I have a legal throttle ( I carry a copy of the legislation). Also brake...
-
JJohnD135 replied to the thread Modifying to Torque Sensing.Hi Mechaniker. I will try looking into that. Harrys. I use 37 Volt batteries and about 1.4KWattHours. I haven't measured the capacity...
-
JJohnD135 replied to the thread Modifying to Torque Sensing.So is there a controller that has a better algorithm than my old S-KU65 please?
-
JJohnD135 replied to the thread Modifying to Torque Sensing.Concerning Harrys last comment. I went back and checked and i was mistaken. I have three large pins. I claim old age and poor eye...
-
JJohnD135 replied to the thread Modifying to Torque Sensing.I currently have an S-KU65 controller and an 810 control panel. This is cadence control. There are two drivers for a change. First...
-
JHi All. I am considering modifying my old cadence sensing ebike to torque sensing. I see that Woosh have a kit to do this, but I am...