Recent content by Markb

Hi Jamie, I just weighed my charger and it comes in just under 800g. Dimensions are 170 x 170 x80mm (approx). Mark

I did some more investigation into the lights fitted to my pro connect today, or more specifically the power source for them. I was expecting 6v DC but the multimeter was measuring much lower than this in both ac and DC modes. As I was at work, I got an oscilloscope out to check the waveform and...

stand over height Hi Erica , I have the 49 cm diamond frame ProConnect (19 1/2 " centre of cranks to top of seat tube) and I measure the top of the cross bar to be 31" halfway along it's length. As Falstaff says it slopes downward from the handle bars to saddle but I think halfway is roughly...

The wires on my rear light are not bare where they enter the light fitting, but I haven't taken it apart yet to see how they are connected. It is on my list to upgrade the lights - both halogen and not very bright. A word of warning about the front light fitting - I have damaged the...

There is a fuse that protects the lights on the pro connect - it is located just above the motor and is accessed by removing all the plastic covers around the bottom bracket, then pull out a kind of plastic sock from the left hand side of the bike. There are some connectors and the lights fuse...