Recent content by Mars

The e-bike in that first video is definately derestricted...

Some really weaselly comments in this thread. Pedelecs going down hill again.

My trailer is still going strong- original cost was £75 from ebay. It has moved a bog (that pic was taken while waiting in the queue at the recyling centre), sink and pedastal in another load. Heaviest to date was a cut up door and a load of soggy chipboard from old kichen cupboards. Think I...

I have the bikybox. Bought to hold a second phylion battery so will be big enough for a helmet unless you have a big head like me. Has a small hole for a padlock.

Changing C2 from 0 to 1 and the hub became silent. Will test properly later in the week. Many thanks for the help vfr40

Sorry, I missed that I missed that in your previous message. That will keep me occupied this week going through the combinations! Many thanks for the help. Incorrect combinations can damage the motor?

I connected like to like as per the attached. You talking about the 3 (blue,green & yellow) bullet ended connectors?

Are KT sinewave controllers supposed to make the motor produce a sound reminiscent of a dentists drill? Just turned a few heads going down the towpath while testing it out! Sound was worse at low speed and when using lower than 3 PAS levels, reduced to a 'quiet' whine at 12mph. Also noticed...

Ah OK. There was no LCD before - just LED so that makes sense. Will try 0

Sensor should be internal from the motor as I understand things 6 wires from motor cable, connected to the white connector P2 set to currently to 6. Wll try 1 now

Incorrect setting for C1. Set to 5 and PAS works Not getting a speed on the display?

OK parts delivered & fitted. PAS has a red light when rotating crank but gives no pedal assist? Motor turns when using throttle (P4 st to 0). Motor W oscillates on the LCD3, increases to aound 60 before reducing back to 30 Used this vid for settings (I left everything to default P1 = 87)...

Controller Display Using the following will allow reusing existing motor cable? 50cm Julet 9Pin Waterproof Extension Cable for Brushless Hub Motor to KT Controller Going by the connectors shown on the images for the controller on the torquetch wbsite, my existing PAS & brake sensors will work...

Thank you for replying Nealh Here are photos of the connector at the hub end Think the penny has dropped; I will need a new cable runnng to the hub from the new controller!