Menu
Menu
Search
Search titles only
By:
Search titles only
By:
Log in
Register
Search
Search titles only
By:
Search titles only
By:
Electric Bikes
Conversion Kits
EMTBS
eRoad/Commuting
What's New?
Menu
Home
News
Forums
New posts
Trending
Search forums
What's new
New posts
New media
New listings
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
matthewslack's latest activity
M
matthewslack
replied to the thread
Trailer for 806?
.
Probably. It is all about the rear axle, which is where most tow hitches are fitted. If there is enough axle length to add a 3mm steel...
Jul 27, 2025
M
matthewslack
replied to the thread
Yamaha PW-ST Motor Jerky
.
I don't know the Yamaha like I know Shimano, but it may be just as simple. One big connector from battery to motor and two small wires...
Jul 26, 2025
M
matthewslack
replied to the thread
Yamaha PW-ST Motor Jerky
.
A crack in the mounting hole makes no difference. A crack through to the sensor could well be the problem. A magnet passing a working...
Jul 26, 2025
M
matthewslack
replied to the thread
Yamaha PW-ST Motor Jerky
.
The magnet also needs to pass the correct part of the sensor. On Shimano, that is the top end of the straight bit, before the round bit...
Jul 26, 2025
M
matthewslack
replied to the thread
Rain effects
.
On some mounts the bottom compartment can be opened up, and it is sometimes used as a space to house the controller. So you can probably...
Jul 26, 2025
M
matthewslack
replied to the thread
Off grid battery charging
.
Solar controllers are inherently limited by the amount of solar attached. The Elejoy specs indicate maximum power capability of 400W, so...
Jul 23, 2025
M
matthewslack
replied to the thread
Pendleton Somerby: Access to the headset
.
Is the cover clamped in place by the stem mounting, or by spacers? There must be something holding it if not threaded?
Jul 23, 2025
M
matthewslack
replied to the thread
Battery woes again
.
Don't try to bring individual cell groups up to full voltage unless you are sure you fully understand the risks. If you leave it...
Jul 23, 2025
M
matthewslack
replied to the thread
Help!
My next project
.
A frequency meter attached to one of the hall sensor outputs would shed a bit more light.
Jul 23, 2025
M
matthewslack
replied to the thread
Off grid battery charging
.
Hydro generators are the goto solution for big sailing yachts these days.
Jul 22, 2025
M
matthewslack
replied to the thread
Fazua power keeps cutting out
.
I may have misunderstood - I thought it was fine with the other battery.
Jul 22, 2025
M
matthewslack
replied to the thread
Fazua power keeps cutting out
.
That sounds again like a knackered battery. Do your tests on the other bike push the battery as hard?
Jul 22, 2025
M
matthewslack
replied to the thread
Crank removal
.
Try heat as well, and a big socket not a spanner. If necessary drill a hole through the spanner flats for a bar, or reshape them with...
Jul 22, 2025
M
matthewslack
replied to the thread
Crank removal
.
If it is like this... ...isn't the end a 1/2" square socket drive? In which case use your longest, strongest Tommy bar and if...
Jul 22, 2025
M
matthewslack
replied to the thread
Off grid battery charging
.
That's a lot of battery. Good side to that is that it does not matter so much about charging as you ride because the range is...
Jul 22, 2025
Top
Bottom