Recent content by mcd

Is it possible that the button on your hand controller is stuck down? Do you still hear a click when the button is depressed? This happened to mine and I ended up opening it up and spraying in some silicon lubricant.

Nuvinci support was very helpful, and was going to ship me a new hand controller, which gave me the nerve to open it up and take a look at what might be wrong. Having looked inside there, I don't remember seeing any quick way to disconnect a bad controller and swap in a new one without...

I once had an issue where the selector button would become stuck down when pressed because it rubbed against the inside of the hand controller case. Fortunately I still have a picture I took when I was emailing Nuvinci support. I was able to open it up and spray a small amount of silicon...

Is the connection secure at the rear wheel where the cable and hub connect? There's a sleeve around the connector that has to be pulled back to disconnect\reconnect. Right by that connection is an indicator light that should flicker red and green when pedaling. With your left hand lean the...

The software and updated firmware are here: http://harmony.fallbrooktech.net/ If you put in your real name and email on that page they may notify you when there's an update, but you can put anything into the fields and press submit and you'll be sent to a page with the download link. You...

I got mine off of Amazon but I found this on Ebay: http://www.ebay.co.uk/itm/Shimano-DXR-BMX-Race-Sprocket-Cog-14-15-16-18-T-tooth-cog-silver-CS-MX66-/151295543551?var=&hash=item2339eac8ff The installation isn't hard. You loosen the nut holding the Harmony to the axle and you just wiggle the...

Sure, you may send the post to them. I did the work myself because like you I'm far away from 50cycles. Changing the rear sprocket was the most involved because the rear wheel had to be removed but you could have that done by any local bike shop. And, like I wrote, my ideal pressure on the...

I'm a Sahel Harmony owner. Once I got the bugs out I've been loving it, except for it being kind of heavy. Right out of the box the configurable setting for wheel size was set wrong, to 2160mm instead of the correct 2030mm, in two places. The size was set wrong both on the display panel...