Recent content by Mike C

  1. M

    bbs02 power cutting out

    Hi, I have exactly the same issue with my BBS02 48v 750w. Do you know if there is anywhere you can get this type of battery load tested? I'm based in North Wales not far from Chester. Cheers, Mike.
  2. M

    Bafang BBS02 Error Code 30

    Fitted my new controller (from eclipse bikes), working perfectly, thanks for everyone's help !
  3. M

    Bafang BBS02 Error Code 30

    I think the fact I'm getting 10v at 5v terminal suggest the regulator is fried and if I can't get to it I may as well buy a new controller but that's a job in itself! Anyone know the best place to get one? Either that or someone who can fix mine. Thanks for your help, it's much appreciated
  4. M

    Bafang BBS02 Error Code 30

    I've found a post on how to check mosfets http://www.ebikes.ca/documents/BlownMosfets.pdf Any idea if there's one on how to check the regulator & hall sensors?
  5. M

    Bafang BBS02 Error Code 30

    I've just checked the 5v connection and I'm getting about 10v. I'm getting about 50v on the P+ and about 40 on the PL. I got my programming cable today and I can get it to connect to the computer but I can't get the option to read flash. I also read this article...
  6. M

    Bafang BBS02 Error Code 30

    So does that point to a broken LCD or controller? I might have to bite the bullet and order one or the other !
  7. M

    Bafang BBS02 Error Code 30

    In North Wales about 5 miles from Chester
  8. M

    Bafang BBS02 Error Code 30

    If I'd wiped out the LCD wouldn't it be dead - it still comes on and reads code 30?
  9. M

    Bafang BBS02 Error Code 30

    Thanks, how can I check for voltage with the LCD plugged in to power the bike up?
  10. M

    Bafang BBS02 Error Code 30

    Thanks Neal, When the LCD powers up the display shows flashing empty battery - is this what you mean or should I be checking with a multimeter?
  11. M

    Bafang BBS02 Error Code 30

    Thanks Woosh, I'll switch the trunk cable as soon as it comes and take it from there. In the mean time I've seen a thread for testing the mosfets in the controller so I'll give that a go while I wait bikeless !!
  12. M

    Bafang BBS02 Error Code 30

    Hi all, I was moving the cables around on my bike yesterday. When I plugged the green 5 pin connector back in I must have twisted it and it bent the pins causing them to short and cause a flash! (In hindsight I should have taken the battery off but I didn't...!) I've hand to strip back the...