Recent content by Naycrx

Good afternoon, I have a 36v 350w yose power rear hub drive with a built in controller with the battery holder. A few weeks ago the power kept turning its self off. I contacted yose they sent me a new battery under warranty. I have since managed to do 3 rides on it now problem around 75...

Good evening, Yes of course, I'll get some photos for you Tommorow.

Good Afternoon. I have a few parts from what I would call a learning curve! 36v 350w motor. About 6 miles on this. Then my tyre rubbed through the motor cable. Blue and white wires split in half. Will need solder. Split half way down cable. I have a yose battery plate, with a speed controller...

Good evening, brief history of my e.bike , I purchased a Boardman cyclocross bike, and fitted a Yose e.bike kit. It’s a 36 350w it has the controller built into the battery base. so far in the 9 months I have had it I have completed 4000 miles trouble free. while I was out riding the other...

N No motor only, and cradle and controller only, untested since the tyre rubbed through the two wires 36v 350w

Hi, I just wondered if anybody on here would be interested in buying a YOSE 350w motor- my tyre rubbed through the cable slightly , it skimmed the top of the blue wire but still in tact , and snapped one of the other thin wires in there. I also have a speed controller , its the sort that has...

Yes I'll go and pick a meter up.... Tried the wheel, do. You mean remove the wire that goes into the axle? I spun it, yes freewheel one way and resistance the other way

That's very kind of you, but your about 150 miles away... Do you know of anyone in Nottinghamshire? After uncovering the black cable, a thin green wire had snapped and took a bit of the blue plastic off the thinner one, obviously they were touching. I have rejoined them, but when thee...

Brilliant thanks for the help, to be honest I'm not great with electronics. Considering buying a new kit as I need it for commuting. Not sure if I could sell the old one for spares or repair

Also..... Does anyone know of anyone in the Nottinghamshire area that could look over it? I'm not aware of any shops?

Hi, Completed a very successful 90miles on my yose kit 350w kit. Unfortunately on my way home today, my tyre rubbed through thee motor cable. Its plugged from the controller to motor, its skimmed the top off a thickish blue wire and snapped a very thin green cable..... I joined it back...

Hi.... I have just come home from work, and I. Got strange vibration through the bike, the motor stopped and flashed error 11 and then stays on error 24? It trys to drive and then cuts out and flashes thee error codes Any ideas?

Thanks , ill have a look at putting it on the chain ring I think. thanks for the help Kit used for the first time this morning, 12 miles Battery reading started as 40.15 after ride 37.00 and battery symbol still on full bar. I used the bike with throttle only helping me up hills etc...

My yose kit is here... Mid install... And found the clip on disc type sensor, just gets squashed when you tighten the crank arm back up?..... I have seen they also do another sensor in the accessories range

It's the clip on disc type I have