Recent content by nazmul789

What number is used for p15? As everywhere I look it says "not implemented now', but my one allows me to change the number. 48v 1000w with LCD Voilamart motor with 52v 16ah battery. If anyone can help me with the optimal settings for P07, P14 and P15 I would be much grateful. Thanks :)

Anyone who purchased this kit, did you use the tyre and tube they supplied on your MTB ? OR did you use your own ones?

Can anyone advise me on why the tyre doesn't close the gap between the rim and the inner tube. I noticed that my rim is very thin in width suggesting it is more suited for a road tyre without the inner tube. I've tried 2 mountain tyres with their inner tubes and the same result occurs. The tyre...

Ok thanks I’ll look into that!

I’ve managed to pump up the tyre now, however it doesn’t fit tightly against the rim, the tyre just just keeps getting wider but doesn’t seal onto the rim.

I didn’t install rim tape. It has an inner tube. Nylon tire, alloy rim & stainless steel spokes. I just measured the rim diameter from edge to edge going through the centre using a tape measure, it was near 23”. Perhaps that’s the reason why the tyres don’t fit. Does this mean that I need to buy...

Hi Courty I have the same kit but I am having troubles installing the tyres and valve onto the rim (compete beginner). I try pumping the valve but there is still so much space left to fill and the tyre just seems too big for it. I believe the tyre size is a 26*1.95, is this the correct size as...

I'm currently in the process of building my voilamart 48v rear kit. One problem I am facing is the tyre they gave me doesn't fit the rim and valve. I try pumping the valve as much as possible but the gaps still doesn't get filled up by the tyre. Can anyone recommend the exact size tyre needed...

By this you mean, cut off the bullet connectors on the controller, then solder the APP wire to the controller yh? I have a soldering iron kit from Amazon it's 60w I think, will that do the job?

I was given a soldering wire, I’m guessing this is to connect the Anderson to the bullet connector by soldering the wire into the bullet connector which is on my controller. Do I need to chop any wires (from my controller/battery). I’m no expert in electric wiring so don’t want to make a...

My battery came with the Anderson adapter (I think). However they gave an extra extender adapter which they gave me. Do I have to solder that to a bullet connector. My controller has bullet connectors for the positive and negative battery terminals. I have the voilamart 48v controller system. My...