Nealh's latest activity
-
Nealh replied to the thread Motor cutting out, thoughts?.When fitting a PAS I never fit the disc to the axle , I prefer to bolt the disc to the inside of the smallest chain ring . There is no... -
Nealh replied to the thread Motor cutting out, thoughts?.It shouldn't slip if you hold it , it should be firm enough to resist slipping. The plastic spline can and do lose grip , you have...
-
Nealh replied to the thread Motor cutting out, thoughts?.I made mention to the motor connector in #23, #32 and #56 which you finally picked up on.
-
Nealh replied to the thread Motor cutting out, thoughts?.A new disc is aligned with the accompanying disc so actual disc diameter matters not.
-
Nealh replied to the thread Motor cutting out, thoughts?.If the disc is slipping on the axle then one has to find away to stop it.
-
Nealh replied to the thread BBS02B - possibly short-circuited?.Yes the fuse has blown, when I enlarge it one can can see ragged edges in the middle.
-
Nealh replied to the thread Motor cutting out, thoughts?.You haven't replied at all as regards to the hub motor connector , one needs to check it is corrctly inserted all the way ti the...
-
I very much doubt that it's a bent axle unless you've done something really daft. Can you give us a better description of the knocking...
-
Nealh replied to the thread Motor cutting out, thoughts?.Mosfest either work or don't work , the exception is thermal cut outs when they get hot and need to cool down again to begin the...
-
Nealh replied to the thread Motor cutting out, thoughts?.No need to test fets as the motor works. Mosfet tests only confirm controller failure by pin pointing the issue, it takes out any guess...
-
Nealh replied to the thread Motor cutting out, thoughts?.3 - 6mm doesn't give a strong signal strength , it any at all.
-
Nealh replied to the thread Yosepower battery cut out.How senior is the kit ? Likey a shagged out battery possibly. One reason why the BMS cut's out , the cells maybe hitting LVC to easily.
-
Nealh replied to the thread Applying Stickers to Hub Motor.Isopropol cleaner .
-
Nealh replied to the thread Advanced Vehicle Engineering (AVE ) User manual.One needs to confirm whether there is any battery voltage output to the controller. The display needs power to power it on , so one has...
-
Nealh replied to the thread Motor cutting out, thoughts?.I can understand it when we give some posters short thrift as often they don't listen or carry out some simple test that are asked of...
