Nealh's latest activity
-
Nealh replied to the thread Motor Blown Up?.It appears to be the ( 6 pin Julet connector ? ) motor connector, as Steve has now got the motor working I would opt to solder and... -
Nealh replied to the thread First post so be gentle.Tyre pressure is a personal thing, some like hard tyres and some like a softer tyre which can aid comfort. It really depends on the...
-
Nealh replied to the thread Motor Blown Up?.It is not usual for the motor connector to melt , when faults occur they are more then often at the controller end.
-
Nealh replied to the thread First post so be gentle.41.5v - 42v is that which one should see for a fully charged 36v lion battery.
-
Nealh replied to the thread Motor Blown Up?.Only the three thicker Phase wires Green , Blue & Yellow are the ones that carry the higher current. The other three are Hall wires...
-
Nealh replied to the thread Motor Blown Up?.Cut the connectors off and solder the opposing wire directly together , not forgetting to slide a bit of heat shrink along the wire...
-
Nealh replied to the thread More Seizures.For the most part illegal bikes are at free will to roam around the town where I live, esp the fast food riders , I often have to pass...
-
-
Nealh replied to the thread Battery Fires.Whether the new thisis still prevalent as it goes back to Jan of 2024 the UK gov't back then branded UPP triangular batteries as...
-
Nealh replied to the thread Motor cutting out, thoughts?.The Yose is a std 9 pin connector , I was more thinking about the one on your bike. If it is also 9 pin then it will be compatible . A...
-
Nealh replied to the thread Motor cutting out, thoughts?.If the motor connector is the std 9 pin Julet moulded type then one generally can use any motor without the need to change anything...
-
Nealh replied to the thread The Mystery Ingredients For DIY Bike Chain Lubricant..The real mystery ingredient in any snake oil product is........... The gullible that buy it and then swear by it.
-
Nealh replied to the thread The Mystery Ingredients For DIY Bike Chain Lubricant..Yep, keep it simple and no snake oil products needed.
-
Nealh reacted to Sonar.sonar's post in the thread The Mystery Ingredients For DIY Bike Chain Lubricant. with
Like.
I use engine oil and have no problems chain run through a oily sponge then run through a clean cloth . done this way back in the early 70s -
Nealh replied to the thread Power cable too short.I used soft flexible butyl because anything stiffer if snagged could likely crack /snap the mudguard.
