Nealh's latest activity
-
Nealh replied to the thread Help! eBike Battery Connector Issue (feeling like an idiot).Cut the bullets off and solder on an XT60, then one doesn't need an extra adapter in between. Or simply cut both connectors off and... -
Nealh replied to the thread KT controller, KT LCD3 and pass - guide on working modes.P2 will typically be value 01 for most hubs as prettymuch most of them use only one magnet for sensing , however if the odo reads very...
-
Nealh replied to the thread KT controller, KT LCD3 and pass - guide on working modes.Does the PAS red LED blink on/off as the magnets pass the sensor? With that type of sensor head positioning/cable tieing in place is...
-
Nealh replied to the thread KT controller, KT LCD3 and pass - guide on working modes.Any KT issues are setting issues and nearly all issues are associated with incorrect PAS set up's. Personally I have never yet...
-
Nealh replied to the thread KT controller, KT LCD3 and pass - guide on working modes.C3 set to 0 or 8 . C3/5 means PAS will always operate at max current set. C7 Cruise control turn off so set to 0.
-
Nealh replied to the thread KT controller, KT LCD3 and pass - guide on working modes.Which PAS model is fitted ? This dictates the C1 value. Are brake sensors fitted ? If so disconnect them.
-
Nealh replied to the thread Freego LIght Folding Bike pedal assist "stuck on".One will need to be methodical so before thinking electrics , rule out any mechanical part of the drive train being at fault . So chain...
-
Nealh replied to the thread Freego bike spares and/or repairs.The Freego uses generic china electronics using PAS /cadence . One can retrofit any generic PAS/cadence system if the old is deemed...
-
Nealh replied to the thread Freego LIght Folding Bike pedal assist "stuck on".One needs to know whether it is a mechanical issue causing the PAS to activate or if it is an electrical issue. Mechanically one needs...
-
Nealh replied to the thread Hello from new user.Sound like a bot answering .
-
Nealh replied to the thread Ananda m100 Motor/ D10 display Throttle addition.One will have to double check the Aussie laws, here in the UK a thumb twist/half twist aka throttle are illegal for EN15194 EAPC's...
-
Nealh replied to the thread Tingsheng TSDZ2B, wired up but motor not kicking in.The Bullets battery power connection need removing , use an XT30/XT 60 or if you like an Anderson power pole. One doesn't really need...
-
Nealh replied to the thread Tingsheng TSDZ2B, wired up but motor not kicking in.Tsdz2 doesn't work if it doesn't see a speed sensor either so yes needs the chain on. With TSDZ2 one will get an error on start up if...
-
Nealh replied to the thread Help! My next project.It is very rare for a motor wound for a particular V to be under volted , we usually like to over volt 24v or 36v for more speed or...