Recent content by newmanoid979

Good Day Many thanks for your reply, i am trying to rebuild my original Hongzer 250 watt 36 volt ebike hub but the stalling point seems to be the PCB board, the original one had Hall sensors at 60 degree intervals and is 100mm long and my thoughts were to extent the sensor wire to reach segments...

Good Morning My fault this may explain better fig A 0986 is the PCB boards from my original ebike hub fig B 0984 is a PCB board that i have managed to purchase fig C 0985 are Hall sensors ang with 3 wires red black and blue fig E 0987 shows the 2 PCB boards together As can be seen they are...

Good Day I have Hall sensors with Red Black ( center ) Blue wires Which way round would the wires be connected to a Hall Sensor PCB board looking at it in a clockwise direction Kind regards Bill

Good Day Just a query is the string net that keeps the stator motor wires in place a special kind of thread if so where would i obtain it or is it just normal string also what would be the best glue to hold this net and the Hall Sensors in place Many thanks Bill

Many thanks i will look into this Kind ragards Bill

Good day Would anybody be able to identify my e Bike hub motor and manufacturer as i am looking to rebuild it after a miss - hap i am trying to find a suitable Hall Sensor PCB board with sensors the original had 3 Hall sensors and a red speed sensor It was from a company called Hongzer (...

hi the hub was fitted with Hall sensors but i had a miss-hap when the wheel dropped out the front forks and ripped out the wiring i have taken steps to ensure this should not happen with the replacement wheel but i would like to rebuild the original wheel hence the need for a pcb board and hall...

Good morning Where would i buy a PCB board with Hall Sensors for a 250 watt 36 volt e bike front hub as the only ones i have seen on the internet are of the wrong arc kind regards Bill

good afternoon what do hall sensor do and what is the results of leaving them out many thanks Bill

many thanks for your help

will an e bike motor work without sensors

Good morning Learned Sir Could you Good Morning Learned Sir Once again i seek your advice could you tell me what the type of connectors are on an ebike conversion , i have Molex connectors but what are the type in the photo your humble student Bill

many thanks bill

I have 1 more question the Violamart controller has 6 wires going to the throttle and display but the KT controller has only 5 plus a separate display i have attached photos of the KT connections but i am unclear aboult what goes where can anyone help many thanks Bill

Good Afternoon the Juet connector was fitted to my original wheel and took me over 25 miles unfortunately are no longer available which is why i ended up with the Violamat wheel would it be a case of matching up the colors , the Juet connector has 9 wire 3 power cables 1 blue ,1 green and 1...