Recent content by redstar99

I've just resoldered the blue wire back on the circuit board, and put it back together again, and it now works....the motors kicking in now so I'm up and running again, looking at your last post Vfr400 you may be right! even though it's working now, when the rear brakes pulled there is no signal...

OK thanks for the info Andy, it look`s like the fault is intermittent now when I put it together, another thing maybe is the magnetic field that I subjected the reed switch to may be to strong for it and may have pushed it beyond it's tolerance.....who knows? I will try another reed switch and...

Sorry....spelling error up there ^^^^ should be Repelling each other!

Hi Andy I can only see the reed switch that Vfr400 pointed out, and the two magnets on each cable that's all. hopefully once I put it back together tonight it should work. but!......does the way you put the magnets inside the multi box matter? do the magnets have to be put in with both...

and here's another one.....you would have thought that the magnet would have closed the switch to give continuity, but looking at it, it seems closed?

the switch seems open circuit at the moment on the reed switch, I did a continuity test and got no audible beep to show it was closed, even when I waved a magnet in close proximity to it....here's a closer picture of the reed switch.

that would be an easier option than the rig that's been put together on the circuit board....I'm not up on all these types of reed switches but it sounds better than what I have set up and a lot less hassle, I will think how I'm going to do this.....will I have to use that circuit board?

initially when I connected the magnets to the cable wires inside the box and fit it back together, the error code was still flashing, when I pressed the rear brake the error code stopped but I still had and exclamation mark on the display, I took it out for a ride but the motor didn't kick in at...

here's a photo of the other side of the circuit board

another pic of the multi box and magnets

there barely 5mm wide, I've tried to actually just let them connect magnetically to the brake cable inside without fastening them down but this has not worked either.

here's how small the magnets are 10mm.

here's a pic showing where I think the magnets should go.....but I tried super gluing them there and it didn't work.

here's looking down where the brake cables go.

here's the two mini magnets.