Recent content by seasidesoul

Ok, will do thanks

Hi, is this a geared motor? It isn't mentioned in the listing. Thanks

So they should all be wired in the same orientation? The wires are colour coded & easy to follow so I'm certain they were as I mentioned. Interestingly, the original owner of this motor said it had never worked. I assumed it had a bad controller hence fitting the brainpower unit, but maybe it...

I think the sensors broke due to mechanical stress because I tested them after the short incident & did move them a bit whilst doing it. You might be right though. Do you think they were wired correctly originally, from my description?

I did the test & I'm getting 12.5k on all v- to phase wires & 1 on all v+ to phase wires. On disassembly of the motor I discovered the sensor wires have all broken at the 3 hall sensors. I'm not sure if this happened before or after the E 09 fault. Unfortunately, I had to destroy the sensors to...

Ah sorry, I'm using the same controller/LCD as the other posters on this thread so thought it'd be ok. I'll start a new thread in future. Thanks for your reply, I'll try your suggestions tomorrow.

Hi, hope it's ok to ask this here... On a new installation with new parts, I'm getting the E 09 error code. No noise or movement from the motor. During assembly I stupidly caused a short due to forgetting to disconnect the battery. However, everything seems fine in the LCD display with the...