Recent content by Steve Dyson

  1. S

    Help! ERROR 08 upon Setup

    Hi, i have this error crop up every now and then on mine, and then disappear. it only happens when i am on full throttle and on PAS/Throttle setting 2 the way i got round it in end was to test the voltage from the throttle, so the P+ and P- should read 5v or near as and the sensor wire...
  2. S

    Wanted Looking to buy faulty Hub motor - tell me what you got

    Nice one mate, i am in Stacksteads, i travel down whitworth road every morning to work, busy rebuilding battery today and adding some capacity, will come over once its done and fully charged. Inbox me your address and i will message you when i am sorted
  3. S

    Wanted Looking to buy faulty Hub motor - tell me what you got

    Sorry i missed your last post, i am in OL13 0HN
  4. S

    Wanted Looking to buy faulty Hub motor - tell me what you got

    Defo interested in it, not sure anything about it or what its value is so will have to take a look and get back with what i think, unless you have an idea
  5. S

    Wanted Looking to buy faulty Hub motor - tell me what you got

    I think that sounds very reasonable, and would like to go ahead with that deal
  6. S

    Pedalling resistance with a powerful motor

    I find that with mine, once i am above about 12 mph i have very little resistance but then i commute daily on mine so want to arrive fresh to work so it suits me, you are probably better with a 350W motor and controller
  7. S

    Wanted Looking to buy faulty Hub motor - tell me what you got

    no worries, just let me know
  8. S

    Wanted Looking to buy faulty Hub motor - tell me what you got

    no worries, just let me know the full cost of what you are wanting for the lot
  9. S

    Help! I need more power (not speed)

    i tore the dropouts on my first build, rear hub luckily as it spun out and split the cable... i had already replaced the hall sensors so i knew the wiring inside, so not a massive job to do
  10. S

    Wanted Looking to buy faulty Hub motor - tell me what you got

    I am looking for some faulty hub motors to A: see if i can repair them and B; try and build some Verticle Axis Wind Turbines from them. Let me know what you have and what the initial fault was.... IE: juddering - Np power
  11. S

    Voilamart Front wheel kit

    I have 2 of the rear hub kits and to give you an honest review of them i would say they are great for the money, there are a couple of drawbacks that i have found and will list them down below. Pro's Hub motor is great, powerful and will take over volting, i have 2 1500W motors and they have...
  12. S

    Road Legal 250W - wow never again

    You are spot on neal, even running lower power on the 1500W just doesnt feel right lol
  13. S

    Road Legal 250W - wow never again

    That sounds like what i need to look at for this one as i want the person that this is built for to have a good experience, on the flat it will do fine and pull at 20+ mph but as soon as it hits a hill it just slows down to a crawl. I have no doubt that there will have to be pedal power to get...
  14. S

    Road Legal 250W - wow never again

    When i first got it, i tested what i could get out of it and had it up to 57 mph pushing 2500 Watts through the motor... Yes i think i have defo been spoiled