Sturmey's latest activity
-
Sturmey replied to the thread KT-LCD8S Screen Symbol (and power stopped).I think that's the brake symbol that usually activated by switches on the brake levers. Check out that the levers are returning... -
Sturmey replied to the thread 3-D Printer.Guns printed with 'cheap, commercially available 3D printers' have been found in Ireland...
-
Sturmey replied to the thread Bafang clutch.I would try soak in petrol first and then relube with 3in one.
-
Sturmey replied to the thread Bafang clutch.I would not use any water based degreaser as it may cause some rust.
-
Sturmey replied to the thread Bafang clutch.Try working some 3in one oil down into the clutch and wiggling it back and forward. Sometimes it works.
-
Sturmey replied to the thread Greasing up the TSDZ2B.I have similar about 7200Km up on a 36v (2020) tsdz2 which I have never opened and it still goes. The motor has been trouble free so...
-
Sturmey replied to the thread 250w Ebike Kit with KT Controller.I think my dropouts were wide enough so that they did not need widening as such other than a slight rub to remove some flaky paint. I...
-
Sturmey replied to the thread Torque Simulation with Yose Power Lishui Controller.Any test certs I came across for EN15194 compliance, shows that "Assistance shall be provided only when the cyclist pedals forward"...
-
-
Sturmey replied to the thread Connector confusion..I think I will have that problem shortly (but the other way around) as I have to upgrade a controller from 22A to 35A and they have...
-
-
Sturmey replied to the thread 250w Ebike Kit with KT Controller.I fitted a rear hub motor to a Carrera Vengence about two years ago. The rear dropout look almost identical to the Hellcat. It worked...
-
-
Sturmey replied to the thread Old Giant struggles with hill..I spent a bit of time with a push button throttle but I could never get it to work satisfactory. It seems to work great in the shed but...
-
-
Sturmey replied to the thread Meroca dropper seatpost - any good? Oh, and someone's nicked me bike!.I understand. I tend to fit a smaller wheel at the back for this reason. At present I have a 26 inch rear on the Carrera Vengence...
-
Sturmey replied to the thread KT controller cutting out at 36V?.I had a possible similar problem once with a well used phylion battery (10S5P). The battery would cut out at about 36v. I opened the...
-
Sturmey replied to the thread Lishui Controller Modification - Firmware Flash Project.I think its usual to use the battery current to control the motor power and this gives a more natural feeling. However, it can be useful...
-
Sturmey replied to the thread Pendleton Somerby e bike fault.I think a bad cell group can cause the battery management (BMS) to cut the battery power under load. The pendleton (that I am familiar...
