Sturmey's latest activity
-
Sturmey replied to the thread Don't get no respect. Wife doesn't like new conversion..I think I can see your wife point of view. 220W may not enough at times and may be too much at other times. I think the motor rpm is... -
Sturmey replied to the thread Help! My next project.I wonder are you using an older square wave controller rather than the more modern sine wave controller. There has been reports on this...
-
Sturmey replied to the thread Help! My next project.I am inclined to think that good performing motors with KT controllers dont like being hobbled/restricted to 25 Km/hr. The motor is just...
-
Sturmey replied to the thread Help! My next project.There was a discussion lately where a recently fitted AKM had similar problems ...
-
Sturmey replied to the thread Help! My next project.Aikema in their catalog below divide their hub motors into two categories, inner rotor and outer rotor. The inner rotor type does not...
-
-
Sturmey replied to the thread Help! My next project.I find what you say above interesting. I changed my front motor from a MXUS to a AKM 100 and found the same. But I think they are two...
-
Sturmey replied to the thread Help! E-scooter battery and controller to an eBike front hub motor.I looked at your photo. The white speed wire is not connected (and I presume you cant find somewhere to connect to) as I think the...
-
Sturmey replied to the thread Help! E-scooter battery and controller to an eBike front hub motor.The scooter instructions are a below. . This may potentially cause two problems if you use this control system for an e bike motor...
-
Sturmey replied to the thread Help! E-scooter battery and controller to an eBike front hub motor.I came across (I think) something like what you describe with a Himo C20 ebike. The bike is fitted with a 20 inch direct drive motor and...
