Recent content by Thefastest

hi my controller has a 6 piece of 085r5nt mosfets they are good but when controller heats up controller lost a much power. they Maximum Power Dissipation 160w@25w but its fall 100w@70c can i change them to ncep023n85 with a better cooler? i think about directly install on a scooters chasis for...

found the problem. my magnets are small than the other. they have 1 or 1.5mm thickness. when the motor heats up my hall sensor must be damaged. orginal sensor is ah41 normally its need 30 gauss to change their situation. i change them 41f and its need to 40 gauss change their situation. when i...

Dont feel like that people doing weird things you are right to suspicious :) I would like to change. But all the controls and brake sensors at hand enter the screen and communicate with the controller with only 4 wires from the screen. 5v rx tx gnd. I can't find a controller like this. I have to...

Yes i did connect with this cable i made. firstly connect to battery. hearda little spark so its filled. i will re check hall sensor cables and sockets :/

İ tried 1000uf 63v capacitor no change at all. should i change the capacitor inside of the controller? Has 3 of 470uf 100v capacitor i can change all of them to 63v 1000uf.

Ok i will try it tomorrow thanks

Thanks for the reply. Do you think battery is the problem here? i can feed controller with 2 battery for testing it. I have a question When i play with the shunt wire and increase the power of the motor, the magnetic field increases too. Could this magnetic field be disturbing the reading of...

Hello i got a e scooter 600w i did shunt mod on its controller first week it was ok. but yesterday suddenly i got e16 error (motor hall anomaly when hit throttle Hard on start. Otherwise there is no problem if i accelerate slowly everything perfect if i Over 20kph of speed when hit throttle no...