Recent content by wattrider

status

Hi, Here is a link to the code that I am using on the ebike. https://1drv.ms/u/s!AsvMp0dGC3dzhJ1Tx591L7hEcdDBlA?e=eE4r7W Originally, I used a fixed value of 50V for the power calculation. This is now changed to reading the battery voltage from a voltage divider which is sampled from the...

I am in Melbourne Australia where we are currently restricted to travel within 5km of home for essential reasons only. I will PM you the code, I forget now which version it is based on, although it is rather old with a comments date of February this year when I started experimenting with it...

OK on your experience. I also have the L7 display and found the ESP32 version to work well as described. The hardest part was obtaining the Julet plug and socket to put inline with the display. These were ordered from a German website, and arrived quite quickly. I also added a bit of code to...

Thanks, I tried it out and it worked. Output range was between 0.8V and 4.3V from off to full throttle.

That is my understanding as well. I have built up the ESP32 interface from the German Pedelec forum which works well and was going to experiment with the messaging in conjunction with the throttle.

Thanks, I will give that a try later.

Does anyone have the pinouts for the Das-Kit throttle connector? Its a 3 pin Julet socket (female pins). I believe its the same one used on the C7BBT display (Moscow etc.). As it seems to be a hall effect throttle, I would rather not experiment with combinations of the pins in case it gets...