Recent content by wehey

I didn’t get a reply back and so just decided to connect the white wire back into the loom…….and hey presto, it all works perfectly now

I have managed to get an email to Justin at Grin. if anyone knows it will be him. im waiting for his reply.

Hiya all i have an Ezee motor approx 2 years old. when I got it I had to wire in an L10 connector to make it compatible with my Baserunner controller. during the process I noticed an extra thin white wire, along with the usual hall and phase wire. I contacted the vendor to find out what it was...

Does anyone have an Ezee rear motor 250rpm sitting idle in their shed?

I dont suppose you still have any of these?

Thanks for that. I have no power to the display either and I don’t use brake cut off switches….. so I guess it’s the controller? Can the HD controller be used in the 02?

Hiya all. I went for a ride a few weeks ago and all was fine with the bike. It was dry. yesterday i decided to go out again in the lovely weather but nothing is working, no life in it at all. i have checked all the connectors and they are all fine. I have voltage the motor side of the battery...

It's a long shot but I don't suppose you have an Ezee V2 rear hub 250rpm?

Back to it. I have stripped the motor down and as far as I can see, everything is as it should be. Is there anyway of testing it whilst it’s apart? Also, would It be likely to run properly with a controller like a Phaserunner?

Thanks So I have tested the hall wires and they all register 4.65v I have tested all combinations of the phase wires and they all shown a positive number on the lowest setting (0.6) It freewheels the same as the other Ezee wheel does.

No i have tested the phases or halls. I don't know how to do either of these?

Would the motor still run if one of the phase wires was faulty Is there any way of testing them?

So I have now tried all 36 combinations. 2 of them produce the same symptoms as in the video and 1 runs the motor but is worse than the other 2. I'm at a bit of a loss as of what to do now? I will fit and wire up the old motor for now whilst I do some more research

Do you mean the hall sensor wires or the phase wires. Sorry if it’s a daft question but I’m not too clued up about this part of the motor

It’s definitely not a winding issue. @ 48v the 250rpm should do 26 mph and the 350rpm should do 29 mph :)