Recent content by Wimi

Hi Guys Apologies if I have confused the issue I hope this clears it up. The Bike was purchased in 2013 and all the wiring is inside of the frame (oldcontroller.jpg) and the controller (B3.jpg) is inside the base of the Bottle Battery Holder. As the original Battery is dying and I was unable to...

Hi Nealth Unfortunately my KT-LCD1 display does not have the Option of C parameter settings, unless I am having a " Mans " look. I have attached Photos of the PAS, LCD, Controller, motor and Manual if that helps

Hi Vfr40 Thanks for that but if my P4 =0 and short out the throttle, then my wheel does a slight ± 1/10 turn and then stops. No further rotations. If I set P4 = 1 nothing happens at all. I have tried with my P3 setting 0 and 1 and the same result occurs.

Hi Nealh Thanks I managed to get the P2 setting to work and reflect a more realistic speed, I also believe that my PAS should be working, as the little red led is now active, as I don't have a throttle, I have I have left my P4 at 0. However I cant seem to get the Motor to engage while peddling...

Thank you

Hi Nealh Thank you for this, do you have any more info on what these P settings are for? as P1 goes from 0 to 999, P2 I am assuming is for the number of magnets in the Pickup as it goes from 1 to 6, P3 and P4 look like they are a simple on /off switch, and P5 is like P1. Thanks again for...

Hi All My Bafang 250W Rear Hub motor died and I Replaced it with a BFSWX02 36V 350W Bafang Rear Hub Motor, Now when I ride the bike the speed on the LCD is totally irrational, I might be doing 4 km/h and the spedo say 45 km/h. I thought that this was because the original controller was for a...