Search results

\\\\\\\\hi, I had an issue my hall sensors on my hub motor sometime ago now, I put a number of photos on here showing my progress , One became disconnected from its signal wire under the Heat shrink insulation. difficult to find. the sensors are very cheap so I replaced all 3. I had a similar...

Hi Chaps, Its taken a while to start work on the Hall sensor replacement, I've been waiting for parts, tool and stuff coming from ebay. The problem seemed to be the joints from the sensor wires to the wiring loom were only held together with the heat shrink wire insulator, no actual solder ...

Hi VFR, Just found a problem, The sensor wires that run from the motor plug to the sensors, 1 is detached from 1 wire that comes out of the sensor. It was hidden inside the heat sleeve that sits on one of the motor coils. if the motor had a circuit board it probably would not have happened or...

Hello VFR, Your indications for not failed are true, but the 5v point was not confirmed, I didn't get to complete the check thoroughly. Motor Failure...... A long moorland road, 2 mile-ish, Max power (5), stopped a couple of times on the climb up, after stopping Third time, set off for last...

There are 6 wires in the Block, 9 in the cable extension. Had trouble trying to read the numbers on them , they are embossed not printed.Th best I could do is 3144? & 2nd line underneath 818? but they where worn so not sure....... Tried to get a 5v to the circuit, but struggled, needed another...

Hello VFR, Ref your Q pins & blocks, I made a mistake with info about wires in the White block. Had trouble trying to read the numbers on them , they are embossed not printed.Th best I could do is 3144? & 2nd line underneath 818? but they where worn so not sure.

Hello VFR

Yes, Round 9 pin type with extension.

Hi guy's, djah, vrf400, Eagle, EAGLE your vid post isn't the one I sore. Mine is a 250W motor. The Video I saw was a 250w hall sensor replacement. Its not a Panda kit, which I presume is better quality than mine. This kit came from EBC in Devon ( now closed down) Cost £435 with Batt...

Hi vfr400 MC, Thanks for your help. I have put a friends wheel on my "Bike system" & it ran fine, which suggests everything before the motor is fine. Watched Youtube .. a chap in USA his motor failed, 1 of his hall sensors turning the voltage on & off was down on voltage, changed all 3 it was...

Hello Eagle, Thanks for your very quick response. Yes.. I did see it on Panda & tried to find a number, but the only contact info I could find was email. Its been a fast leaning curve for me as I'm trying to get my bike back on the road as soon as possible with as little expence as I can get...

I have sent a message to Panda Ebikes but not sure if I will receive a response, so I'll post it on here to see if the knowledgeable people on here can shine some light on my problem?....... Hello Panda Ebikes, I have the regular 250W hub motor kit. The motor packed in after 200 miles of use...