Search results

Hi! I will verify that. Thanks. here is an attachment of one discussion with my seller : Hello! I thank you for your answer and know that I read your messages with interest! What I mean with the PAS "0" is that a bad electronic information could interfere with the pedelec and thus produce a...

Good! Waiting for the usb cable programmer, maybe I will try to give a look at the anderson in the controller pod.

hello vfr400!

No luck in my search. Trade-shop was my seller by eBay but I Don't find any traces of my buying...

it's a 36V battery

but I haven't yet the usb cable programmer! So where can I find these characteristics? (continuous and max current)

I think the pas 0 is in the cause...

I turn the panel off. I have brake and gear cut out and I try without them and it's the same song...

Maybe it's electricity remainings that are the cause

At the handbar panel

it's a mid-drive! that's why I am very embarrassad to understand the slowdown...

when this slowdown occurs, if I cut the assistance, the ebike instead of freewheel, brakes.

the seller told me that my battery 36V 11.6A could be the Reason, that it would be better to have a 15A. hem...

peter c is there! thanks! I have ordered a usb programming cable and I will receive it between the end of october and end november. But will you be there at this time to show me what settings it would be necessary to change?

ha yes vfr400, you're right. This buzzing was a too large chain! I changed for a better size! but I am very doubtful that a reprogramming of my controller will solve the slowdown which I experienced when the pedelec is working regularly. these slowdown occur for 2-3 seconds and I lose 2-3 km/h...

peter.c I understand very well what you write. I will probably do that. Thanks.

That's what I wasn't sure! Directly solder the wire between the support of the battery and the controller. I did that (A). But I encountered problems with the engine slowing down without warning and without leaving the pedelec.Believing wrongly that my branch A was involved, I changed...

KirstinS thank for your help! But tell me, Don't you think it's possible without XT60 and dirctly connect the cable from the controller to the battery. That's what I want to know for sure.more precisely to the support of the battery.

Howdy! You will find attached a diagram that reproduces 2 ways to connect the bafang motor to the battery. This is a mid engine. Tell me if the 2 possibilities are passable or which is the best. Thanks.

So lezallib I want to hear your "clunking" sound! My motor too makes a Strange sound! And more than just a sound….I feel Something vibrating just when I pull away!