Search results

hi i have just changed over to a 36volt battery do i have to change any parameter settings thanks in advance for any help given

it was showing before i set the p and c parameters up when i press the up and down buttons together is shows end where the motor reading normally is there a wat to set it back to factory settings and try again

Does anyone know why i am getting a sour 2 on my my lcd3 please and how to rectify it also I’m getting an end on the motor part

thank you vfr400

thank you just another question what ampage ones would you use as the wire is only thin isnt it

thank you pal sorry i didnt explain it right the pedal assist in the pic is for a coyotte connect electric bike im hoping to use a spare bike thats why i was asking if i can terminal block it

Here are the new and old pas sensors on the new one its all male connectors on the controller side its two male and a separate female would I be able to block connect the two male and the female together as i haven’t got the female new parts for them it’s for a coyote connect that I’m hoping to...

thank you neath for replying il set it all up in next couple of days and hopefully it all works ok just hope the throttle works properly too

Hi neath this is the pas sensor I got with the kit it is a ten magnet one thank you for all the info you sent

Hi im wondering if anyone can help me please. I have a cyclematic powerplus 24v 250watt motor bike and ive just fitted a kt lcd3 does anyone know what the p and c parameters are for this bike please also when i press the throttle sometimes it kicks in and other times it does not any help would...

Would this do to extend the battery connections to the controller connections decided to put it in a bag as scared of breaking wires trying to get it inside the space obviously I’d get the male part too...

This is the controller I got and this the space for it to go in

No don’t think so the batter part where the battery connects to goes into the compartment I have tried all sorts of ways to get it but just won’t go in this a pic of the connector from the wheel the cable would connect to the controller am I right in saying this

Vfr400 yea it does pal then goes to the controller

to do that tho would have to open the motor up and im no good at stuff like that

vfr400 do you have any links to the parts i need or does anyone else thanks for any help given

Hi neath I have tried to get the wires in there but can’t and dnt want to break any of the wires so the other option sounds the better way to go but will have to extend the wires like I’ve said would be better if i can get one the same so there is no messing about just plug it all together

Hi vfr400 this the space where the controller goes tried every way to get the wires in but can’t so looking at your other option you gave me I would have to extend the motor phase wire and the hall sensor connector also the battery wires do you know where I can get the part from with the...

was this one i got im sure it was https://www.amazon.co.uk/Pswpower-6Mosfets-Brushless-Controller-KT-LED890/dp/B077XDBWZ8

hi pal i got the one you advised me to on one of my other posts about cyclematic power problems i think it was i only just managed to get the controller in the space where it is supposed to go had to put all the connectors through the hole that leads into the compartment