Search results

Are theese locks easy to replace with a new one once opened

I can get a key for £133 +vat which is a bit steep, i was looking to fond a less costly alternative

Does anyone know if it is possible to get a replacement key from a lock number. I need a TKM key lock no 3248, for a lombardo e ike

Closure. Clone battery returned. New battery controller installed as original was fused by clone battery. Original battery re installed. Back on the road.

Left the replacement on charge all day even though the charger was green. Outer two pins show 11v inner 0v. If you disconnect charger outer two show 18v. Confusing but interesting. The main controller shows a resistance of 65 ohm on the positive and ground pins and the power transistors. All the...

Replacement battery is a sf03 from ysbattery

I am at work at the no so I can't check anything yet. I can confirm the original battery has no on off switch. When you put the original battery back on the display runs the start up then has a flashing no 2 indicating a fault.

Hi pin 1 on the left is ground. On the original battery pin 2 0v pin 3 0v pin4 0v pin 5 0v pin 6 41.8v. New battery fully charged charger shows green. Red power switch under Meath does not seem to do anything. Voltages are pin 1 is ground. Pin 2 0v pin 3 0v pin 4 11.4v pin 5 0v pin 6 11.4 v.

Orig battery 41.8 v on two outer pins. New battery only at 11.4 v on two outer pins

Yes what do you recommend I check

If I don't I will have to pay to get it repaired. The bike won't work on the old battery which is perfectly ok so it seems the replacement has shorted out the controller. So I either buy a replacement original controller and stick with the original 9ah battery, or upgrade to a new controller and...

Well looks like a new controller is the best option as the bike will not now work with the original battery. Which part in the battery case is the controller the circuit board with the 6 pins or the black box on top

Hello forum. I cycle 16 miles to work so I have been looking for a larger battery. My bike EC03 uses a 6 pin joycube Phylion. Got a 6 pin Phylion from ysbatt this fitted but now the bike won't run. On pressing the controller light 2 flashes then lights 1&2 flash. Does anyone know what error...

Ok thanks for the help

Hi I have had the controller apart. Pics to follow I can't tell how many wires there are.

Ok fair enough. I will need to check how I get the controller housing apart to check the wiring. Essentially you are saying that unless I buy the actual joycube battery one that looks the same and has the same pin count may not work. This is good point as even the replacement battery cost too...

Hi I appreciate the help but I am not yet at the stage of takin the controller apart. My first option is to get a 6 pin battery that will fit and work. There is a 6 pin battery from e life which is 11 ah. Ideally I would like a 13ah. Currently with my 8.8 I do 10 miles on reduced power and then...

I know I have a smart b.s. the battery can only be charged with a 5 pin charger. However can you assume all 6 pin batteries (pins that connect to the controller) will be smart as well?

Wow this is really complex. I will check out the wiring before I change the battery . Thanks for the help