Search results

Would something like this actually work? https://www.ebay.co.uk/itm/Li-ion-lithium-Battery-Charger-for-electric-bicycle-e-bike-36V-42v-VOLT-XLR-plug-/264387055133?mkcid=16&mkevt=1&_trksid=p2349624.m46890.l6249&mkrid=710-127635-2958-0

Thank you both for the replies. It sounds like I'll need to do a bit of research but looking on eBay etc., it appears that the Giant chargers are around £120+...!!!! I'll have a look at my existing charger for the 36v lead acid battery pack and see what kind of voltage that outputs.

I was dropping off a trailer load at the local recycling centre last week and a woman was about to toss an Energy Pak Battery (Giant) into one of the containers. I said I could possibly repurpose the battery and I'd take it if she didn't mind. Was thinking of using it on my old school lead acid...

NMDP

When you have something like this old bike, with no known spec or details etc...it's obviously setup to use 36v but what would occur if say 48v was used instead? Would it simply blow the controller or burn out the hub motor?

I watched a few videos on YouTube where they tested a variety of 18650 batteries and most were only a fraction of their rated capacity. I'd suspect something like this type of battery may very well be made from the same low grade cells? Also read about the dubious practice of putting new...

Does this seem too good to be true? US $71.71 39%OFF | 36V 20AH 10S4P electric bicycle battery pack 18650 lithium ion battery 500W high power 42V motorcycle scooter https://s.click.aliexpress.com/e/BRpaBpPiL

This bike was really just a project to see if I could get it back up and running. I knew the square root of nothing but at least now I know that somebody telling the battery is perfect isn't something to be taken at face value ;) I'm perhaps thinking of selling this one and using the money to...

The price of the first one is attractive, as it would be a bit more than double the price of replacing the lead acid batteries. :)

Sorry didn't notice your earlier reply. I don't know the full history of the bike but I'm led to believe it was kept on the back of either a camper or a caravan. It doesn't look like it was actually used very much, tyres look original and are very much unworn. The grips still had plastic...

On another note, here's the batteries that I was using. Now that the problem has been resolved, it's time to think about upgrading the current power source. Should I just buy three new NP12-12's and save a lot of hassle and effort or should I switch to another solution. I've got some...

Well, glad to report back with success! :) I firstly re-soldered the discharge positive connector cable...and put some insulating tape around the terminals, more on that later... Put in a fresh fuse and used 2 x 12-12's and 1 x Yuasa battery. Now all taped up and re-installed back...

Start of the strip down, discharge connector soldering looks pretty suspect... Live terminal is only hanging on with a few strands of cable. I'm absolutely crap at soldering but I'll give it a shot! :D

I've done a start to tearing down the bike end of the connection. Here's the wiring that comes from the hub motor. Which two wires do you think will be the ones?

It was working fine on Monday. Just tried to give the old batteries a final "revive" before deciding on buying new replacements. Then the problem with the fuse blowing.

Here's some other photos I took of the bike earlier in the year when I was still scratching my head! I was told the battery was good and it measured "good" when not under load ;)

The (Yuasa) security batteries were just being used for test purposes. The system is 3 x 12 (12-12 batteries) and one was goosed at 8.9v, the Yuasa 12v batteries are the same length but narrower - using 2 x 12-12's and 1 x Yuasa battery gave around 3/4 miles of assisted range which wasn't too...

I can try this in the morning. Would that just be a case of disconnecting the cables from the controller wiring? It's just somewhat strange it was all working fine, then the fuse keeps blowing.

I've not checked yet but I'm suspicious that one of the terminals on the bike end might be grounding onto the frame or suchlike. The battery box has been checked and rechecked multiple times and the wiring arrangement is pretty fool proof internally. I'll see if I can get some photos in the...

The original was 20A . I've been through about 4 of those yesterday, then today I tried a 25A and a 30A. Battery turns on fine with no load but as soon as it's on the bike and the switch is turned you can hear the fuse blow.