Search results

...So small, even the bus driver didn't see it. WM Bus driver didn't like my e-bike - YouTube

I've been getting power fluctuations over the last few days so I decided to check out the phase connectors. The insulation on the 3 bullet connectors was blackened and welded to each other. On pulling them apart some bare connector was showing. The male/female sides were also completely...

Anyone? I've taken the bolts out but can't budge the side. The data sheet (pdf download at bmsbattery) has an exloded graphic but I can't tell whether the side screws on or not.

Hi all, I'm using a Q100, 201rpm, 36V, 250-350w motor with an e-crazyman 36V, 350w EB306 controller. I'm programming with XPD and wondered how far I could reasonably push the current settings.

I'd like to wire a brushless hall motor so that it runs normally in reverse. I'm thinking that swapping the A and C phase wires should do it but would I need to swap the hall sensor wires too?