So I've replaced the 3 cogs that make up the gearbox on my Bafang CST 36V 500W. My motor was built in 2013 so it has the 4-keyhole clutch like all pre-2015 models.
When I took it apart, this bit fell out and now when I'm putting it together again, I can't figure out where it's supposed to go.
I've tried it in various positions but it just doesn't seem to fit anywhere that makes sense. I can put everything back together just fine without it but doing so with such a large solid piece missing does not exactly inspire confidence.
When I took it apart, this bit fell out and now when I'm putting it together again, I can't figure out where it's supposed to go.
I've tried it in various positions but it just doesn't seem to fit anywhere that makes sense. I can put everything back together just fine without it but doing so with such a large solid piece missing does not exactly inspire confidence.