So I have just purchased an ebike and been reading loads from the forum as I have a couple of issues..
Firstly error e42 keeps popping up (very frustrating as not had chance to test properly) hope someone can shed some light on this
Secondly I have delved into the controller to see if any wires loose and found a red wire unconnected to anything .. would this be from factory or could this be my problem... ??. Its not a bare wire like it's broken its heat shrinked and convincingly like a sensor .. could it be a heat sensor or is that me clutching at straws...
The bike dose work inbetween the error code and feels ok ish .. I'm not 100% they ate linked as I belive the motor has had it.. and the wire could be an unused wire possibly..
Any advice would be really helpful,
Firstly error e42 keeps popping up (very frustrating as not had chance to test properly) hope someone can shed some light on this
Secondly I have delved into the controller to see if any wires loose and found a red wire unconnected to anything .. would this be from factory or could this be my problem... ??. Its not a bare wire like it's broken its heat shrinked and convincingly like a sensor .. could it be a heat sensor or is that me clutching at straws...
The bike dose work inbetween the error code and feels ok ish .. I'm not 100% they ate linked as I belive the motor has had it.. and the wire could be an unused wire possibly..
Any advice would be really helpful,