Hi all, I recently fitted a Cyclotricity 250W front hub kit from Powerbikes on my touring bike (with PAS and not using throttle as it wont fit the drop bars) and all was fine until I tried using the instructions to alter speed limit and wheel size, as per this pdf on the Powerbikes website: https://powerbikes.uk/images/ekit-led-dashboard-user-manual-3rd-edition.pdf
However it just did not work as per the instructions, the speed adjustment mode, with low power and speedo lights flashing, did not allow any adjustment, i.e. it did not respond to pushing either on/off or mode buttons. In the second mode, with med power lit, the wheel size could be altered so as an attempt to approximate an mph readout on the speedo I changed the wheel size setting to 4 bars, i.e. 18". The bike rode normally but the speedo only showed one bar at around 10mph, two bars at around 15mph, three once I had gone well above the limit of assistance, much lower than I had expected. I have since gone back in to reset wheel size to 10 bars i.e. 28" but the speedo is still showing the same very low readings, so looks like I have messed something up. Could I have accidentally changed a parameter in the P1-P5 settings as per this pdf http://www.szktdz.com/upload/file/20140813/20140813081138_34669.pdf ?
However it just did not work as per the instructions, the speed adjustment mode, with low power and speedo lights flashing, did not allow any adjustment, i.e. it did not respond to pushing either on/off or mode buttons. In the second mode, with med power lit, the wheel size could be altered so as an attempt to approximate an mph readout on the speedo I changed the wheel size setting to 4 bars, i.e. 18". The bike rode normally but the speedo only showed one bar at around 10mph, two bars at around 15mph, three once I had gone well above the limit of assistance, much lower than I had expected. I have since gone back in to reset wheel size to 10 bars i.e. 28" but the speedo is still showing the same very low readings, so looks like I have messed something up. Could I have accidentally changed a parameter in the P1-P5 settings as per this pdf http://www.szktdz.com/upload/file/20140813/20140813081138_34669.pdf ?